Dusk LED Lighting System from ZOHD – ZOH1000-001
Brighten up your RC model with this easy-to-install lighting! This LED Light Set from ZOHD provides a convenient way to illuminate your RC airplane, helicopter, drone, or other vehicle. Five LEDs (1x Green, 1x Red, 3x White) are provided with pre-soldered connectors and long wires to reach the wingtips of a park-sized RC airplane with an approximate wingspan of 1400mm (~55”). The LEDs are mounted on PCB “spikes” that are especially easy to mount on foam airplanes.
Simply position the LEDs on your model, run the wires back to the included DUSK Control Board, and provide power to the Board with 7-24 volts. The DUSK Control Board can be remotely toggled between three Light Modes using a three-position switch on your radio transmitter. These three modes are: Lights Off, Navigation Lights ON Only, and Navigation Lights and Landing Light ON.
Adding LEDs not only enhances the realism of your RC model, but also increases its visibility and resulting safety while orienting it at further distances.
Features:
- Bright 5V LEDs mounted on easy-to-position PCB spikes
- Pre-soldered connectors for convenient tool-less installation on your vehicle
- DUSK Control Board provides consistent power to each LED
- Remotely toggle between three modes (requires its own channel on your radio transmitter and receiver)
- 3 Light Modes: Lights Off / Navigation Lights / Navigation Lights and Landing Light
- Wide input voltage range of 7V-24V
Includes:
- 5 LED lights (1x red, 1x green, 3x white) with pre-soldered wires/connectors
- DUSK LED Light Control Board
Requires:
- 7-24 volts [either from a 2s-5s battery, or a separate battery pack]
- A spare receiver channel and radio channel to toggle between Light Modes
